AiM G-Dash - Manual (Page 18)

CHAPTER 7 INTERACTION WITH SMARTYCAM
34 35
G-DASH
Interaction with SmartyCam.
G-Dash communicates with SmartyCam via
the CAN-bus through EVO4 datalogger.
To connect both G-Dash and the
SmartyCam to EVO4 ‘EXP’ port you will need
a Data Hub.
SmartyCam
To visualize up to 16 channels of data sampled by the EVO4 (including ECU based data) on
SmartyCam generated videos, you must configure your EVO4 with the Race Studio 2 software
and send the configuration to the SmartyCam. In the Race Studio 2 software, follow this path:
“Device Configuration”>>“EVO4”>>>“SmartyCam functions setting”.
If you find the channel you are looking for, select it and associate it with SmartyCam function.
If you do not find it in the list, select the “Enable Channel for all Functions” checkbox to verify
that the channel is being supplied by the EVO4 (ECU and others) as all available channels will
be shown.
When you have all of the channels set that you are interested in, click on the “OK” button and
then the “Transmit” button at the top of the page. The “Functions to Channels” information will
then be automatically sent to the SmartyCam.
The panel below appears.
It shows functions that can be displayed on
SmartyCam video (left) and channels (ECU
and others) that can be assigned to that
function (right). The drop down menus show channels (ECU
and others) coming from EVO4 grouped by
type (i.e. on Water Temperature you will
find all of the temperature channels).