AiM LCU-One Analog ver 1.02 - Manual (Page 5)

LCU-ONE Analog
User Manual
Release 1.02
2
Chapter 3 – Configuration
To work properly LCU-ONE Analog needs to be configured. The configuration can be
made both using Race Studio 2 and using Lambda Configurator the free software -
included in the kit - properly designed and developed by AIM to configure this device.
5
3.1 – LCU-ONE Analog standard configuration
Configuration through Race Studio 2 (standard) is possible only if calibration curve
default points – 1.95=0.65 and 4.8=1.6 – have not been modified.
To configure LCU-ONE Analog with Race Studio Configuration follow this procedure:
• run the software;
• press “AIM system manager” button on the left vertical keyboard;
• select the logger LCU-ONE Analog is connected to
• activate “Channels” layer
• select the analogue channel to set the probe on
• double click on “Sensor type” column corresponding to that channel and
select “AIM Lambda LCU-ONE 1.65 – 1.6 Lambda)” option as shown here
below; click out of the cell to confirm the choice.
www.aim-sportline.com 4