AirLive Ether-GSH2416W - Manual (Page 7)

7
1.2 Configuration Functions for the Switch
After the login is successfully validated, the switch’s home page – System page will show up. The
left part on the page provides the function menus (shown as below) to activate to the individual
configuration page.
The function menus contain two parts: Switch for setting up the switch functions and System for
maintaining the system parameters.
Switch functions contain:
„
Port Status – to show port link status and configure port parameters
„ Port Statistics – to show packet statistic results passed through each port
„ VLAN – to configure port-based or 802.1Q (tag-based) VLAN
„ Trunk – to build up the trunk function
„ Mirror – to setup the port mirroring function
„ QOS – to configure the Quality of Service function
„ Rate / Storm Control – to limit the traffic rate and suppress the broadcast storm
System functions contain:
„
System Setup – to configure the required system information (such as IP address, etc.)
„ User Management – to maintain the login information to access to the switch
„ Backup / Restore ♣ – to backup/restore configurations to/from TFTP server
„ Reboot / Reset – to reboot the switch or reset configuration to default values
„ Logout – to log off the system
♣ Some models don’t support this function