AirLive POE-FSH2442G - Manual (Page 12)

AirLive PoE-FSH2442 User’s Manual 5
Figure 2. Combine the Switch with the provided screws
Then, use screws provided with the equipment rack to mount each switch in the rack.
Figure 3. Mount the Switch in the rack
3.4 Connecting Network Cable
The Switch supports 24-port 10/100Mbps 100BASE-TX Fast Ethernet and it runs both in half and full duplex
mode using two pair of Category 5 cable. These 24 PoE ports will be automatically activated when a
compatible terminal is identified. The Switch will supply power through the PoE port to the connected PD.
For Legacy devices that are not yet compatible, the PoE port will not offer the power to these devices. This
feature allows users to freely and safely mix legacy and Power over Ethernet compatible devices on their
network.
The Switch also supports 4-port 10/100/1000Mbps 1000BASE-T Gigabit Ethernet that runs in Auto-
negotiation mode and 10Mbps Ethernet or 100Mbps Fast Ethernet that runs both in half and full duplex
mode and 1000Mbps Gigabit Ethernet runs in full duplex mode using four pair of Category 5 Cable.
These RJ45 ports are Auto-MDI type port. The Switch can auto transform to MDI-II or MDI-X type, so you
can just make an easy connection that without worrying if you are using a standard or crossover RJ45 cable.
There are additional 2 ports mini-GBIC slot for optional mini-GBIC module.
3.5 AC Power
The Switch used the AC power supply 100-240V AC, 50-60 Hz. The power switch is located at the rear of
the unit adjacent to the AC power connector and the system fan. The switch’s power supply will adjust to the
local power source automatically and may be turned on without having any or all LAN segment cables
connected.