AirLive WH-5410G - Manual (Page 29)

29
Wireless Advance Settings -
The page below can help users to configure advanced wireless setting. Before
making any changes at this page, please check your wireless settings on other
system as well, as these changes will alter the effectiveness of the Access Point.
In most cases, these settings do not need to be changed.
z
Data Rate – In data rate column you can select all bit rate supported in
current operation mode. Default value is “best” means the system will
automatically adjust the connection speed dynamically according to your
current link status.
z Transmit Power – You can reduce RF output power by selecting Half
(-3dB) / Quarter (-6dB) / Eighth (-9dB) / Minimum. To change transmit
power may decrease your wireless signal coverage.
z Beacon Interval (20-1000) – This value indicates the frequency
interval of the beacon. A beacon is a packet broadcast by the Access Point
to keep the network synchronized. A beacon includes the wireless LAN
service area, the AP address, the Broadcast destination address, a time
stamp, Delivery Traffic Indicator Maps, and the Traffic Indicator Message
(TIM).
z Data Beacon Rate (DTIM) (1-16384) – This value indicated how often
the Access Point sends out a Delivery Traffic Indication Message. Lower
settings result in more efficient networking, while preventing your PC from
dropping into power-saving sleep mode. Higher settings allow your PC to