AirLive WH-5420CPE - Manual (Page 31)

28
referred to as a network name because essentially it is a name that identifies a
wireless network.
In this mode, the SSID is provided for client connection.
 Channel Number: Allow user to set the channel manually or automatically. If set
channel manually, just select the channel you want to specify. If
“Auto”
is selected,
user can set the channel range to have Wireless Access Point automatically survey
and choose the channel with best situation for communication. The number of
channels supported depends on the region of this Access Point. All stations
communicating with the Access Point must use the same channel.
 Wireless Client Isolation: This is to separate wireless client if needed. Wireless
clients can not communicate to each other if the field is enabled.
 Site Survey: Site survey helps to find out available access point around. You can also
check to prevent using same SSID or channel with other AP.
To configure the security connection, please refer to Section 3.9 Wireless Security
Settings
……
To configure the Advanced Settings, please refer to Section 3.10 Advanced Wireless
Settings
……
To configure the access control, please refer to Section 3.11 Access Control
Settings ……
To configure the Traffic Control, please refer to Section 3.12 Access Control
Settings
……