AirLive WHA-5500CPE-NT - Manual (Page 22)

3. Configuring the WHA-5500CPE-NT
AirLive WHA-5500CPE-NT User’s Manual 16
The WHA-5500CPE-NT offers many different types of management interface. You can
configure through standard web browser (http), secured web (https), command line (telnet).
In this chapter, we will explain WHA-5500CPE-NT’s available management interfaces and
how to get into them. Then, we will provide the introduction on Web Management and
recommended initial settings. For detail explanations on Web Management functions,
please go to Chapter 4 and 5. For Command-Line interface, please go to Chapter 6.
3.1 Important Information
The following information will help you to get start quickly. However, we recommend you
to read through the entire manual before you start. Please note the password and SSID
are case sensitive.
‰ The default IP address is: 192.168.1.1 Subnet Mask: 255.255.255.0
‰ The default user’s name is: airlive
‰ The default password is: airlive
‰ The default SSID is: airlive
‰ The default wireless mode is : Client mode
‰ After power on, please wait for 2 minutes for WHA-5500CPE-NT to finish boot up
‰ Please remember to click on “Apply” for new settings to take effect
‰ When you set the “Regulatory Domain” to “All Channels”, the WHA-5500CPE-NT
will display all the available channels. However, please make sure the frequency
you select is legal to use in your country.
‰ Please remember to enter the correct “Distance” parameter in wireless settings.
Failure to do so can result in poor performance.
‰ The default country code is : United Kingdom.
If you are living outside of EU, please go to Operation Mode->Setup->Regulatory
Domain to change country.
3
3.
Configuring the
WHA-5500CPE-NT