Bravetti PLATINUM PRO EP542 - Manual (Page 4)

GETTING TO KNOW YOUR DRINK MIXER OPERATING INSTRUCTIONS
Read all the sections of this booklet and follow all the instructions carefully.
4
1
1. Mixing Blades
2. Electrical Switch - (ll) High Speed, (O) Off, (l) Low Speed
3. Large stainless steel ergonomic container.
4. Bracket with Safety Switch - Unit will not operate unless the
container is placed correctly on the switch bracket.
5. Upper interlocking bracket to support the container - always put
container lip behind bracket.
6. Weighted base with non-slip rubber feet gives maximum stability.
7. Motor
Housing
Before Using for the First Time
1. Remove all promotional labels
from the drink maker. Wash
the container in hot soapy
water and dry thoroughly.
2. Clean the mixing blades and
shaft with a damp cloth and dry
thoroughly.
Fig. A
Warning: Do not immerse unit
in water or any other liquid for
cleaning.
Fig. B
Fig. C
Using the Drink Mixer
1. Place the drink maker on a level,
dry surface. Plug the unit into a
120 volt wall outlet.
2. Make sure that the 2 speed switch
is in the center (0) “Off” position
(Fig. A).
3. Combine the ingredients in the
container. Do not overfill the
container beyond the “MAX” line
(Fig. B).
4. Hold the container and place it
into the drink maker. Make sure
that the top of the container
is placed behind the upper
interlocking bracket that supports
the container (Fig. C). The base
of the container should rest on the
bottom bracket pressing on the
safety switch. (Fig. D).
5. Switch on the 2-speed electrical
switch.
6. Choose speed (l) or (ll) according
to the ingredients that you are
using. (Fig. E).
7. When your drink is ready, press
the 2-speed switch to the “OFF”
(0) position to stop the unit
(Fig. A).
8. Remove the container by lifting it
upwards slightly to release it from
the bottom bracket and serve.
Fig. D
Fig. E
Technical Specifications
Voltage: 120V., 60Hz.
Power: 70 Watts
2
3