AirLive WL-5460AP v2 User Manual
Page 34
AirLive WL-5460AP v2 User Manual
35
Ø Channel Number: Allow user to set the channel manually or automatically. If set
channel manually, just select the channel you want to specify. If
“Auto”
is selected,
user can set the channel range to have Wireless Access Point automatically survey
and choose the channel with best situation for communication. The number of
channels supported depends on the region of this Access Point. All stations
communicating with the Access Point must use the same channel.
Ø SSID of Extended Interface: This field is the SSID of remote Access Point to connect
to.
Ø 802.1d Spanning Tree: Spanning tree is to prevent bridge loop when there are
multiple active paths between network nodes. Bridge loop could cause connection fail
or broadcast storm. Spanning tree allows a network design to include spare (redundant)
links to provide automatic backup paths if an active link fails, without the danger of
bridge loops, or the need for manual enabling/disabling of these backup links.
Ø Site Survey: Use this button to find out the remote Access Point and check the signal
strength.
To configure the security connection, please refer to Section 3.9 Wireless Security
Settings ……
To configure the Advanced Settings, please refer to Section 3.10 Advanced Wireless
Settings ……
To configure the access control, please refer to Section 3.11 Access Control
Settings ……
To configure the Traffic Control, please refer to Section 3.12 Access Control
Settings ……