BT Response 15+ - Manual (Page 12)

Response 15+ - Edition 5 – 26th October ’00
10
Press and release the Stop
button.
Your Response 15 Plus will beep
and play back your outgoing
message. It will then beep again
and return to ‘answer on’ mode.
To check your outgoing
message
You can record your own
outgoing message to replace
the pre-recorded message. If
you record your own message,
the pre-recorded message will
be automatically removed and
stored in the memory, in case
you wish to reinstate it.
To record your outgoing
message speak clearly 15–20cm
from the in-built microphone.
Read all the steps before you
begin recording.
Press and hold the Stop button.
Your Response 15 Plus will
beep and display ‘r’.
Keep holding down the Stop
button and speak your message
into the microphone.
When you have finished
speaking, release the
Stop
button. Your Response 15 Plus
will beep, play back your
message, then beep to confirm
the recording. It will then return
to ‘answer on’ mode.
To re-record your message
repeat this procedure.
To record your outgoing
message
Please note
Your outgoing message may sound
something like this: ‘Hello, I’m sorry
I can’t take your call at present. If you
would like to leave a message, please
speak after the tone.’
Stop
Stop
You can delete your outgoing
message and return to the
Response 15 Plus’ pre-recorded
outgoing message.
Press and release the Stop
button. Your outgoing message
will be played back to you.
During playback of your
outgoing message press the
Delete button.
Your Response 15 Plus will
beep and play its pre-recorded
outgoing message.
Your own message has now
been replaced by the Response
15 Plus’ original pre-recorded
outgoing message.
To delete your outgoing
message
Stop
Delete