Belkin AirCast Audio 8820tt00529 F4U037 - Manual (Page 13)

11
AirCast Auto
sections
table of contents 1 2 3 5 4 7 6
InforMATIon
fCC statement
Belkin International, Inc ., is not responsible for any interference caused
by unauthorized modifications to this equipment . Such modifications
could void the user’s authority to operate this equipment .
fCC Caution: Any changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to
operate this equipment .
ICes
This Class B digital apparatus complies with Canadian ICES-003 .
IC
This Class B digital apparatus complies with Canada RSS-210 .
europe – eU Declaration of Conformity
This device complies with the essential requirements of the
R&TTE Directive 1999/5/EC, the EMC Directive 2004/108/EC, and the
low-voltage Directive 2006/95/EC . A copy of the European Union CE
marking “Declaration of Conformity” may be obtained at the website:
www .belkin .com/doc
This device complies with part 15 of the FCC Rules . Operation is subject
to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation .
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules . These
limits are designed to provide reasonable protection against harmful
interference in a residential installation . This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications . However, there is no guarantee that interference
will not occur in a particular installation . If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that which the receiver is connected .
• Consult the dealer or an experienced radio/TV technician for help.