Allen&Heath WZ12 2DX - Manual (Page 20)

WZ16:2DX AND WZ12:2DX U SER G UIDE 20
D UAL M ODE
The effects processor provides two independent stereo effects programs. The first from Aux 5 and the second
from Aux 6.
The effects programs available to Aux 5 correspond to programs 1-8 in the following list and those available to
Aux 6 are described in programs 9-16 below:
PROGRAM 1-8 PROGRAM 9-16
# NAME EFFECT # NAME EFFECT
1 Stage 9 Stage As effect #1
2 Room 10 Room As effect #2
3 Hall 11 Hall As effect #3
4 Plate 12 Slap Dly 100ms delay
5 Chamber 13 Delay 200ms stereo delay
6 Cathedral 14 Echo Stereo echo
7 Arena 15 Chorus Ideal for guitar chorus
8 Gated Rev
These effects are similar to
those in Single Mode
16 Phaser Instrument/vocal phaser
SELECT – This switch is used, in conjunction with the LED column, to choose the effects programs on auxes 5
and 6 in turn. For each aux, the select switch steps through the eight programs and then OFF before cycling
back to the first program of the eight.
BANK – This switch and associated LED selects the aux 5 effect or the aux 6 effect.
MIDI F UNCTIONS
The MIDI in socket provides the capability for selecting between FX programs via MIDI. MIDI program change
numbers 0 to 15 correspond to effects programs 1 to 16.
MIDI Channel Change - The MIDI channel of the mixer may be selected by holding down the BANK key on
power up. Whilst continuing to hold the BANK key, use the SELECT key to step through channels 1-16. The
FX1-8 LEDs will light in sequence to indicate MIDI channels, then the BANK LED will light in conjunction with
these to show 9-16. After cycling through MIDI channels 1 to 16, the processor will then turn all channels on
and then all off. Release both BANK and SELECT keys when the required MIDI status is selected. The BANK
LED will flash twice to confirm channel change.
The factory default is channel 1.
RESET - Holding down the SELECT key during power up performs a hard RESET. The 8 FX program LEDs
will flash in sequence followed by the BANK LED flashing off then on.
This restores the effects programs to the
factory default settings.
RESTORE – Hold down the BANK and SELECT keys while powering up the mixer. The 1-8 program LEDs will
flash in sequence followed by the BANK led flashing twice to confirm the operation.
This restores the MIDI
channel and effects programs to the factory default settings.
W
IZARD
FX’
S
S
YSTEM
MIDI S
PECIFICATION
P ROGRAM C HANGE C ONTROL C HANGE CC N UMBER
1-16 FX Select in single FX mode
1-8 FX A Select in dual FX mode
9-16 FX B Select in dual FX mode
100 FX bypass
101 Exit FX bypass
110 Single FX mode
111 Dual FX mode
112 Wizard front panel disable
113 Wizard front panel enable
16-19 FX1 Param 1-4
20-23 FX2 Param 1-4
24-27 EQ Param 1-4
28-29 NG Param 1-2
31 FX Type
48, 01 Store FX Settings (send twice to confirm store)