Bosch MON170CL User Manual
Page 8
EN | 8
Bosch Security Systems | 6 July 2005
MON170CL | Instruction Manual | Installation
5.2
Desktop Installation
The MON170CL monitor is delivered with a 3-pole US
style power cord and a 3-pole Euro style power cord.
Use the US style power cord where 120 VAC, 60 Hz
power is available, and the Euro style power cord where
230 VAC, 50 Hz power is available.
The monitor end of the power cord plugs into the power
connector at the power adapter. The monitor
automatically adjust to either power input voltage.
5.2.1
Power Supply Installation
1. Turning the locking clip a quarter turn to unlock the
base, as shown in photo A.
2. Lose the clips on the bottom of the base and fold the
base unit up, as shown in photo B.
3. Connect the bayonet connector from the power
supply to the power input connector on the rear side
of the LCD panel, as shown in photo C.
Photo A
Photo E
5.3
Connecting the Composite Video
(CVBS) Input Signal to the Monitor
There is one (1) RCA connector located on the rear of
the monitor for composite video input (Figure 2); also
included is one (1) RCA Jack to BNC converter
(included with the MON170CL) to connect BNC cable
line, as shown in photo D and E.
Photo D
Photo B
Photo C