Allen&Heath Xone InnoFader User Manual
Page 3
3
Whilst holding the cross fader, using the T8 torx driver, remove the 2 screws either side of the crossfader unit
from the front panel.
Unplug the 4way harness from the crossfader PCB.
The original fitted fader (green PCB) will be fitted as below:
To fit the Innofader (red fader), unscrew the original (green PCB) fader from the mounting plate using the T8
torx driver, remove the screws from either side of the fader.
Reverse the mounting plate, ensure the fader and mounting plate are in the correct way.
screw the Innofader as below:
Now fit the Innofader (which is connected to the mounting plate) to the mixer.
Reconnect the harness
Replace the screws.
Attach the fader knob.
Test the mixer for correct operation.
Ordering Spares
The standard fader can be ordered under part number 004-503JIT
The Innofader can be ordered under part number 004-504JIT
The mounting plate can be ordered under part number AA9076
XONE:23 & XONE:23C Innofader Fitting Guide AP9662 Issue 1
Copyright © 2014 Allen & Heath Limited. All rights reserved
http://www.allen-heath.com http://www.xone.co.uk