Allworx for iOS - Manual (Page 11)

Reach for iOS 1.1 User Guide
Toll Free 1-800-ALLWORX * 585-421-3850 Page 3
wwww.allworx.com
Revised: 6/10/14
2 Setup
To use the Allworx Reach application, the Allworx Server Administrator must provide
information about connecting to the server. This includes server IP address or
addresses, username, and password. Contact the Allworx Server Administrator for this
information.
To use the web page setup link:
• Administrators may send a “setup link” to the website http://get.allworx.com/
reach . This setup link includes the server IP addresses and username.
If visiting the setup link on a computer and the device is equipped with a QR
code reader application, open the QR code reader application and capture the
setup code. The website opens on the device.
If visiting the web site from your iOS device using an administrator provided link,
the instructions include an Auto Configure button, which enters the server IP
address and username into the required fields. Additional information is
available at
http://get.allworx.com/reach/reach_faq.aspx .
• During setup, users must manually enter their Allworx password.
To manually download and install the Allworx Reach application:
1. Navigate to the App Store. Search for the Allworx Reach application. Tap the
Install button. The application downloads, and then the configuration page
displays.
Upon successfully installing or updating the Reach application, the Emergency
911 Notice displays. Read this notice, and tap the OK button at the top of the
notice to accept.
2. Open the Allworx Reach application.
Caution:
During an emergency, the technology may not provide the most timely or accurate
location data if used for a 911 emergency call. Calls may be misdirected to the wrong
emergency response center or the emergency response center may make errors when
determining your location. USE THE SERVICE ONLY AT YOUR OWN RISK DURING
AN EMERGENCY. ALLWORX WILL NOT BE LIABLE FOR RESULTING ERRORS,
DELAYS, INJURY OR DEATH.