Installing the lamp using short yoke position, Adjusting yoke, Rotating shutter assembly – Altman Lighting Phoenix Series Ellipsoidal Spotlight User Manual

Page 2: Installing c-clamp

Advertising
background image

Altman Lighting, Inc.

57 Alexander St., Yonkers NY, 10701

1-800-4-ALTMAN

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE. COPYRIGHT 2012© ALTMAN LIGHTING, INC. ALL RIGHTS RESERVED.

CAUTION: Do not use any lamps exceeding 750W,

or permanent damage will result!

CAUTION: DO NOT touch the glass portion of the

lamp with your hands!

CAUTION: Disconnect fi xture before re-lamping.

1. Loosen cap screw until it spins freely.

2. Pull lamp cap straight out from the luminaire body.

3. With protective wrap still in place, grasp lamp at base and

gently push into socket until fi rmly seated.

4. Remove protective wrap from bulb and replace lamp cap

into luminaire body.

5. Tighten cap screw.

INSTALLING THE LAMP

USING SHORT YOKE POSITION

1. Remove T-Handle and its associated hardware.

2. Remove yoke bolts, cup washers and pivot covers. Note:

use a 1/4” hex head wrench to remove yoke bolts.

3. Stretch yoke and snap it into short yoke position.

4. Replace pivot covers, cup washers and yoke bolts.

5. Replace T-Handle into square hole, keeping the washer

between handle and yoke.

ADJUSTING YOKE

1. With one hand on ring handle to hold unit, loosen T-

Handle.

2. Tilt unit to desired angle. Note: Reference angles have

been molded on the pivot cover to make adjustments

easier and more precise.

3. Tighten T-Handle to secure fi xture in place.

ROTATING SHUTTER ASSEMBLY

1. Loosen shutter rotation lock knob on either side of the

luminaire.

2. Rotate shutter assembly 360° in either direction.

3. Tighten shutter rotation lock knobs to secure shutter as-

sembly.

4. To lock the shutters in place, rotate the Shutter Lock Lever

until proper tension is applied to shutters.

INSTALLING C-CLAMP

The C-clamp is used to mount the luminaire to a pipe hang

position. The C-clamp attaches to the top of the yoke via

the 1/2” bolt provided with the C-clamp. Be sure to keep the

washer between the bolt head and the yoke.

LAMP

CAP

SCREW

T-Handles

Lens

Tube

Shutter

Handle

Shutter

Assembly

Cap Assembly

Shutter Rotation

Lock Knob

Short Yoke

Position

Yoke bolts

Cup Washers

Pivot Covers

Shutter

Lock

Lever

Advertising