American Lighting LED Pendant Series Light Module - Manual

WARNING: These products may represent a possible shock or fire hazard if
improperly installed or attached in any way. Products should be installed in
accordance with these instructions, and with current electrical codes and/or
the current National Electric Code (NEC). This light module is intended to be
installed only by qualified personnel.
WARNING: To avoid electric shock, disconnect power at source
prior to installation.
Save these instructions.
Alteration of the fixture or accessories will void the warranty.
For indoor installations only. Do not use where ambient temperature
exceeds 104°F (40°C); suitable for use in environments with 0-80% humidity.
Using this product in environments outside of these ranges will impact LED
life negatively.
For 120V, 60Hz input power applications only. Fixtures consume 7.5 watts
per module. Unpack the fixture and inspect for any damage. If there is any
damage to the pendant cord, LED lens or wire inside canopy, do not install.
Note: Glass shade is sold separately.
DETERMINE OVERALL LENGTH OF PENDANT LIGHT: (See Figure 1)
G
enerally, the bottom of the pendant glass would be 24”-30” above a dining
table or eating counter, but perhaps more clearance may be needed over an
island. Consider surface height, pendant glass height and any clearance
issue(s) when determining overall height.
ADJUSTMENT OF PENDANT CORD: (See Figures 2 and 3)
1. Remove two retaining screws on side of canopy and set aside. Remove
mounting bracket and set aside. See Figure 2.
2. Loosen plastic nut on canopy. See Figure 3.
3. Adjust pendant cord to appropriate length by pulling up through the
canopy to achieve overall height per Figure 1.
4. Adjust position of strain relief ring by loosening pendant cord and moving
ring to location at side of driver. Pull any additional pendant cord through
ring to take up any slack.
5. Screw plastic nut back onto canopy and retighten to secure pendant cord.
CONTINUED ON REVERSE
ADDITIONAL SAFETY MEASURES:
1. To avoid electrical shock, do not turn on fixture with missing or damaged lens.
2. There are no serviceable parts inside LED module.
3. Suitable for indoor dry locations only.
4. This product is suitable for use in dimming circuits. Dimmable with most
incandescent, low voltage electronic and low voltage magnetic dimmers.
The use of chemicals or solvents may degrade the housing finish or its
protective coating. Use only a mild soap and/or slightly damp soft cloth
to clean the fixture. Harsh chemicals will damage the lens and/or fixture.
Do not wipe the fixture with a rough cloth that may scratch the finish or the lens.
Denver, CO 80231 • www.americanlighting.com © 2013 American Lighting, Inc. RV1326 Page 1 of 2
LED Pendant Series Light Module
ru Installation inst ctions for PEN Series Light Module
Figure 3
Plastic nut Canopy
Pendant cord Side View
Figure 1
Canopy
Pendant cord
Frosted
LED lens
Lock nut
Figure 2
Top View
Yellow/Green
ground wire
Canopy
LED
driver
Black
wire
Strain
relief
ring
Pendant
cord to
lighting
module
Mounting
bracket
Black
Wire
Red
Wire
White
wire
Glass shade is
sold separately