American Lighting ALPX Series - Manual

www.americanlighting.com
12V XENON PUCK LIGHT
RECESSED MOUNTING (See Figure 4)
Caution: Risk of fire! Only recess mount puck lights when top of cabinet
is not enclosed.
1. Drill a 2
1 /
8
" hole in the desired location. Note: A 2 ¼" hole will be too
large to hold the puck light in place.
2. Remove lens cover by rotating counter-clockwise.
3. Discard surface ring and screws. They are not needed for recessed
applications.
4. Feed wires through hole and push light housing into hole until it seats.
Its tension-fit design will hold the housing in place. Note: Make sure
there is no contact between the hot lamp, lampholder or reflector,
and the wire or any combustible material such as plastic or paper
goods. Secure the wires to prevent them from contacting the cabinet light.
5. Replace lens cover.
6. For two or three Puck lights. (See Figures 2 and 3)
Take the ribbed wires from the puck lights and twist them together into one connection. Repeat this
process with the smooth wires.
7. Insert the ribbed wire cluster into the side of the terminal block that is across from the ribbed wire
coming from the transformer and screw down the retaining screw to
hold the wires in place. Insert the smooth wires into the hole that is
next to the ribbed wires and tighten screw.
8. Plug the transformer into a standard 120-volt outlet.
IMPORTANT SAFETY INSTRUCTIONS
Warning! Please read the following: to reduce risk of fire, electric shock,
or injury to persons. Lighted lamp is hot.
1. Turn off lights and allow to cool before replacing bulb.
2. Bulb gets HOT quickly. Contact only switch/plug when turning on.
3. Do not touch hot lens, lens holder or enclosure.
4. Do not direct light at persons.
5. Do not look directly at lighted bulb.
6. Keep lamp away from curtains and similar materials that may burn.
7. Use only 20 watt or smaller bulb.
8. Do not operate the light with a missing or damaged lens. Lens acts as a guard.
9. This fixture is equipped with a polarized plug (a plug having one blade wider than the other). This plug
will fit in a polarized outlet only one way. This is a safety feature. If you are unable to insert the plug
fully in the outlet, reverse the plug. If it still will not fit, contact a qualified electrician.
TROUBLE SHOOTING
1. If one or more lights should fail to work: Push bulb into socket to reset pins that may have vibrated
loose during shipping. Replace lens cover and plug in.
2. If one or more lights flicker: Unplug and allow to cool. Check all connections. If system is on a
dimmer, disconnect dimmer.
BULB REPLACEMENT
1. Twist lens cover counter-clockwise.
2. Remove burned out bulb.
3. Insert new bulb. Use only 12-volt type, G4 base, 20 watt or 10 watt.
4. Replace lens cover.
SAVE THESE INSTRUCTIONS
Installation instructions for ALPX Series (ALPX20, ALPX40 & ALPX60 blister packs)
Housing
Lens Cover
Figure 4
RV0906-KB