American Lighting LCL Series - Manual

LED 4590
Installation instructions for LCL Series
WARNING: These products may represent a possible shock or fire hazard if improperly installed or attached in any way.
Products should be installed in accordance with these instructions, current electrical codes and/or the current
National Electric Code (NEC).
Figure 1
1. Do not use improper power supply. The LED 4590 requires a 24V DC power supply (use only types listed below from
American Lighting). These LEDs require DC output. Do not use 24V transformers because their AC output this will shorten
the life of the LEDs and likely cause “AC flicker”.
Do not exceed the maximum wattage capacity of the power supply. Multiple fixtures may be linked together to a single
power supply, but only up to the maximum number listed in the chart below:
IMPORTANT SAFETY INSTRUCTIONS
LCL-12
Item
Number
MAXIMUM NUMBER OF FIXTURES CONNECTED TO ONE POWER SUPPLY
LCL-PS50
(7 watts/each)
6
LED-DR-24*
3
LCL-PS90
8
LED-DR60-24*
8
2.
Do not make connections or link additional fixtures while power supply is
plugged in. Plug in power supply only when installation is complete.
Use in indoor applications only. The LED 4590 is not rated for outdoor use.
Product warranty becomes void if installation conditions allow operating
temperatures to exceed 40˚C (104˚F) or drop below -20˚C (-4˚F).
Do not remove lens or fixture’s endcaps, nor alter the power supply in any way.
The LED 4590 is equipped with integrated LEDs and lens cover. Removal of lens
cover, alteration of power cord, connector, power supply, or disassembly of the
fixture voids the warrantly and may result in shock hazard and/or risk injury.
Unaltered, the power supplies LCL-PS50 and LCL-PS90 are both c/UL/us Listed.
LED-DR-24 and LED-DR60-24 require a LCL-EC72 (sold separately) with the female
jack cut off. Cut back the jacket and strip the leads to 3/8” (white is positive, black
is negative) to connect to the hardwire driver. 3.
INSTALLATION INSTRUCTIONS
4.
1. Install the mounting clips. The LED 4590 mounting clip design allows for both
45˚ and 90˚ mounting angles for installation versatility. Determine and mark clip
locations per installation needs (see Figure 1).
Gently push first fixture into mounting clips. See Figure 2.
Link additional fixtures. Gently push second fixture into
mounting clips and using the inline connector, included with
each fixture, interconnect first and second fixtures by sliding
them together until both are fully connected (see Figure 3).
Connect power supply to fixtures, then plug in power supply.
Only apply power after all connections are complete in order to
prevent any damage to the LEDs and/or the power supply (see
Figure 3).
The LCL-PS50 includes a six foot lead with a mating DC jack.
The LCL-PS90 includes a six foot lead and a 6” adapter cord to
connect into the fixture. If additional lead wire is needed from
the power supply’s location to the first fixture in a single run,
use optional accessory LCL-EC72 (sold separately) to add 72”.
2.
3.
Figure 2
Figure 3
4.
Interconnect fixtures,
connect power supply to
fixtures then plug in only
after all connections are
complete.
www.americanlighting.com
RV-1134KB
5.
Gently push fixture into mounting clips.
90˚ 45˚
Determine best mounting
position. Clip design
allows either 45˚ or
90˚ mounting angle.
(hardwire) (plug-in) (plug-in) (hardwire)
*