American Lighting GC-20 Series User Manual

Led canopy light

Advertising
background image

©2014 American Lighting

Denver, CO 80231 Made in China

www.americanlighting.com

LED CANOPY LIGHT

Installation instructions for GC-20 Series

RV-1435

READ ALL OF THESE INSTALLATION INSTRUCTIONS BEFORE INSTALLING THE FIXTURE. FAILURE TO FOLLOW
INSTALLATION INSTRUCTIONS AND ALL APPLICABLE ELECTRICAL CODES WILL VOID THE PRODUCT WARRANTY.

WARNING:

These products may represent a possible shock or fire hazard if improperly installed or attached in any

way. Products should be installed in accordance with these instructions, current electrical codes and/or

the current National Electric Code (NEC).
WARNING:

Disconnect supply power from the source prior to installation. This product must be installed by a person

familiar with the construction and operation of the product and the hazards involved, and in accordance

with current electrical codes and/or the current National Electric Code (NEC). Consult a local licensed

electrician if you are not sure about the installation. To reduce potential of electric shock, fixture must be

grounded. The electrical input of this product is 120-277V AC. The installer must determine whether

power supply in in the range of 120-277V AC at the luminaire before installation.
Do not mount or support these fixtures in a manner that can cut the outer jacket or damage the wire

insulations. Do not restrict fixture ventilation. Do not cover fixtures with insulation or any material that

will impede air flow around and heat dissipation of the fixtures.

APPLICATION / USE:

This product is suitable for use in wet locations and designed for surface mounting only. This fixture is

suitable for installation where ambient temperatures do not exceed 104˚F (40˚C) during anticipated

hours of fixture operation.

ADDITIONAL SAFETY MEASURES:

1. LEDs are not serviceable. Do not attempt to open the fixture or LED compartment.

2. LEDs are bright. Do not look directly into fixture.

3. Not intended for recess mounting in any type of installation.

4. Do not use with wall dimmers or in dimming circuits.

Note: These instructions do not cover all details or variations in equipment nor do they

provide for every possible situation during installation, operation or maintenance.

INSTALLATION:

Disconnect supply power from the source prior to installation.

Installation requires T20 Security Torx Bit

1. Remove old fixture if applicable.

2. Remove the J-box mounting plate from the top of the fixture

by loosening one side screw and sliding the fixture plate out

from the holding brackets on the top of the housing.

See Figure 1.

3. Install mounting plate to J-box with two screws (not included).

Note: Bracket should be positioned squarely with respect to

the fixture. See Figure 2.

4. Hang fixture from support spring while wiring the unit. Connect

fixture’s lead wires to AC supply wires using appropriate UL

Listed electrical connectors as follows: connect line voltage

(hot) AC supply wire (Black) to the line voltage AC wire (Black);

connect neutral (common) AC supply wire (White) to the

neutral AC wire (White); and connect the ground AC supply

wire (Green or bare wire) to the ground AC wire (Green wire).

5. Connect main housing to the junction box bracket by pushing

the housing up onto the 4 top brackets. Hold in place while

reinstalling the side screw.

6. Turn on power. Fixture will reach full output in several seconds.

Figure 1

Mounting

plate

Fixture

Figure 2

Mounting

plate

Side screw

J-box

Side screw

Advertising