American Lighting AL-3R-6A - Manual

LED Repeater
Installation instructions for AL-3R-6A
www.americanlighting.com
RV-1229R
WARNING: These products may represent a possible shock or fire hazard if improperly installed or attached in any way. Products
should be installed in accordance with these instructions, current electrical codes and/or the current National Electric Code (NEC).
Install in a well-ventilated area free from explosive gases and vapors. Proper operation requires the free flow of air.
PLEASE READ THE FOLLOIWNG CAREFULLY BEFORE PROCEEDING!
CAUTION - To reduce risk of fire, electric shock or injury to persons:
1. BE SURE THAT REPEATER IS DISCONNECTED AT THE SOURCE BEFORE PROCEEDING!
2. DO NOT OPEN THE REPEATER OR ATTEMPT TO SERVICE - THIS COULD CREATE A SHOCK HAZARD AND/OR
DAMAGE THE DEVICE!
3. DO NOT CONNECT 120V CURRENT TO THIS DEVICE. IT MUST BE POWERED ONLY BY 12V OR 24V CONSTANT
VOLTAGE POWER.
4. For all wire-to-wire connections, use UL Listed wire nuts.
5. For all connections to the driver’s terminals, place conductor(s) between the metal plates, wrap it around terminal
screw clockwise so it stays in place as the terminal screw is firmly tightened for strain relief. See Constant Voltage
Drivers’ installation instructions for details.
6. The repeater has triple output (three positive and three negative terminals). Make sure that the total connected
load for each set does not exceed 6 amps (72 watts for 12V; 144 watts for 24V).
7. The operating temperature for the repeater is -20°C to +50°C.
8. The repeater can be powered by the same power supply as the LED lighting load or it can be powered by a separate
driver. See also installation instructions for the Constant Voltage Drivers (PS-25/60/100/150-12/24). There are dual
power input terminals. The single + and - terminals marked “Input” are for the dimmer’s signal so that multiple
runs can be controlled by one dimmmer in unison. See Figure 1 below. The output terminals allow three lighting
loads to be attached, but not to exceed the maximum run of the lighting product itself, nor the maximum combined
capacity of the drivers connected to it (via the input side)
Figure 1
Supply 12V or
24V power to
the repeater
via the dual
power input
terminals.
Connect
dimmer’s
signal (output)
to terminals
marked “Input”.
Connect lighting load to terminals marked “Output”.