American Lighting AL-PWM-6A - Manual

WARNING: These products may represent a possible shock or fire hazard if improperly installed or attached in any way. Products
should be installed in accordance with these instructions, current electrical codes and/or the current National Electric Code (NEC).
For installation in a standard wall box designed for use with wall dimmers and wall switches.
PLEASE READ THE FOLLOWING CAREFULLY BEFORE PROCEEDING!
CAUTION - To reduce risk of fire, electric shock or injury to persons:
1. BE SURE THAT SUPPLY POWER IS DISCONNECTED AT THE SOURCE BEFORE PROCEEDING!
2. DO NOT OPEN THE DIMMER OR ATTEMPT TO SERVICE - THIS COULD CREATE A SHOCK HAZARD
AND/OR DAMAGE THE DEVICE!
3.
DO NOT CONNECT 120V AC POWER TO THIS DEVICE. IT MUST BE POWERED ONLY BY 12V
OR 24V DC (CONSTANT VOLTAGE) POWER.
4. For all wire-to-wire connections, use UL Listed wire nuts.
5. Do not exceed 6 amps of load connected directly to the dimmer. For larger loads, see installation instructions for the
Constant Voltage Drivers (PS-25/60/100/150-12/24), taking note how to use the LED Repeater (part number AL-3R-6A)
in conjuction with the dimmer and multiple drivers.
LED PWM Dimmer
Installation instructions for AL-PWM-6A
www.americanlighting.com
RV-1229R2
WARNING: These products may represent a possible shock or fire hazard if improperly installed or attached in any way. Products
should be installed in accordance with these instructions, current electrical codes and/or the current National Electric Code (NEC).
For installation in a standard wall box designed for use with wall dimmers and wall switches.
PLEASE READ THE FOLLOWING CAREFULLY BEFORE PROCEEDING!
CAUTION - To reduce risk of fire, electric shock or injury to persons:
1. BE SURE THAT SUPPLY POWER IS DISCONNECTED AT THE SOURCE BEFORE PROCEEDING!
2. DO NOT OPEN THE DIMMER OR ATTEMPT TO SERVICE - THIS COULD CREATE A SHOCK HAZARD
AND/OR DAMAGE THE DEVICE!
3.
DO NOT CONNECT 120V AC POWER TO THIS DEVICE. IT MUST BE POWERED ONLY BY 12V
OR 24V DC (CONSTANT VOLTAGE) POWER.
4. For all wire-to-wire connections, use UL Listed wire nuts.
5. Do not exceed 6 amps of load connected directly to the dimmer. For larger loads, see installation instructions for the
Constant Voltage Drivers (PS-25/60/100/150-12/24), taking note how to use the LED Repeater (part number AL-3R-6A)
in conjuction with the dimmer and multiple drivers.
LED PWM Dimmer
Installation instructions for AL-PWM-6A
www.americanlighting.com
RV-1229R2