Black & Decker Spacemaker CG700 - Manual (Page 9)

6 7
1. Place the chopping blade on the spindle in the center of the workbowl. With your
fingers on the top of the stem of the chopping blade, give it a twisting motion
while pushing down to make sure it is securely seated on the spindle (Q).
Important: Handle grinding blade carefully. It is very sharp.
2. Place up to 1¼ cups (135 g) of food to be processed into the workbowl.
3. With your fingers on the top of the stem of the chopping blade, give it a twisting
motion to make sure the food is evenly distributed in the workbowl.
4. Holding the workbowl from the bottom, securely insert the bowl up into the center
of the bottom of the motor housing with the arrow ▲ symbol on the bowl directly
under the UNLOCK symbol on the bottom of the motor housing (R).
5. Turn the workbowl clockwise until it locks into position. The LOCK symbol on
the housing should be aligned with the arrow on the workbowl.
Note: There is a safety feature on this appliance that will not allow the grinder to
operate unless the workbowl is securely in place.
6. Plug in the appliance.
7. Press and hold the ON/OFF control button. To stop the chopper at any time,
remove your finger from the ON/OFF button.
Important: Process foods no more than a few seconds at a time. A pulsing action
produces excellent results and offers greater control.
8. When the food is processed to the desired consistency, release the ON/OFF button.
Important: Be sure chopping blade has completely stopped spinning before removing
workbowl from appliance.
Q
CUPS
R
9. Hold the workbowl securely and turn it counterclockwise to the UNLOCK
position; keeping the bowl level, lower it from the appliance.
10. With your fingers on the top of the stem of the chopping blade, lift it up and out
of the workbowl with a twisting motion. Remove food using rubber spatula
or simply invert workbowl onto plate, bowl or work surface.
11. Unplug appliance when not in use.
HELPFUL TIPS FOR CHOPPING AND BLENDING
• The processor works very quickly. Watch carefully to avoid over-processing foods.
• For best results, process foods that are about the same size.
• Cool cooked foods before processing.
• Do not overload the processor by adding more than 1¼ cups of food in the
workbowl at one time.
• Use this processor to prepare small amounts of cooked fruits and vegetables for
baby food.
• Cut hard foods, such as chocolate, whole hard spices and cheese into smaller
pieces before processing to avoid damaging the blade.