American Lighting CFX2V2 Series - Manual (Page 2)

LED Clear Flex V2 -Single Color
Installation intructions for CFX2V2 Series
INSTALLATION INSTRUCTIONS
1. Disconnect power at source before installation or maintenance.
2. Clear Flex2 requires DC 24V LED Power Supply! Do not connect to 120V AC power!
3. To connect power connection kit to the Clear Flex2:
• Push the pins of the connector kit into the end of the Clear Flex2 making sure that the two prongs make full
contact with both of the internal conductors. See Figure 1.
Note: Polarity is marked “ + - ” on the connector kit and Clear Flex2. If polarity is reversed, the LEDs will not be
damaged. They simply will not operate.
• Apply glue into the heat shrink tube, and slide the shrink tube over the joint where the power cord and Clear
Flex2 meet. See Figure 2.
• Use a heat gun to gently apply heat until the shrink tube shrinks in place over the assembly.
4. To connect the end cap to the Clear Flex2:
• Apply glue into the end cap and push the Clear Flex2 into the cap, until it is fully seated.
• Apply glue into the heat shrink tube and slide the shrink tube over the joint where the end cap and the Clear
Flex2 meet.
• Use a heat gun to gently apply heat until the shrink tube shrinks in place over the assembly.
5. To connect two sections of Clear Flex2 together using a splice connector:
• Slide the heat shrink tube onto one of the pieces of Clear Flex2 to be joined.
• Insert the connector pins into this piece of Clear Flex2 being sure to
make full contact with each of the internal conductors.
• Align the second piece of Clear Flex2 and push onto the connector
pins, making full contact with each internal conductor.
• Apply glue around the surface of both ends of the Clear Flex2
pieces and slide the heat shrink tube over the joint.
• Use a heat gun to gently apply heat until the shrink tube shrinks in
place over the assembly. Note: The glue must make contact with all
surfaces of the joints. Be sure that the heat shrink tube completely
covers each of the joints to maintain IP65 rating.
6. Clear Flex2 can be mounted using the mounting clips or using aluminum mounting channel as shown below.
See Figure 3.
7. Clear Flex2 can be cut every six LEDs (approximately every 3.9“). Cut squarely on the cutting mark. Cutting
anywhere else will result in loss of 3.9” of light (one series parallel section).
8. Connect Clear Flex2 to a 24V DC power supply, ensuring the polarity is correct (red to positive and black to
negative). Do not apply 120V AC power to Clear Flex2! Please also refer to the power supply’s instructions.
DO NOT TWIST, MOUNT VERTICALLY OR BEND ALONG SHORT SIDE:
RV1316 www.americanlighting.com
Lighted surface
Connector kit
Figure 1
Heat shrink tube
Figure 2
Figure 3
Screw
Light surface
Aluminum Channel
Ч Ч
Ч
Ч