AMMCO 940175 Poly V-Belt and Pulley Kit User Manual
Caution, Installation instructions
940175
Poly V-Belt and Pulley Kit
Installation Instructions
AMMCO Tools, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3564
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX
Installation Instructions – 3000 and 7000 Lathes
Discard the pin supplied with
the new pulley. The pin has no
function on the 3000 or 7000
lathe and may damage the lathe if installed.
1.
Remove the v-belt and discard.
2.
Back the set screws fully out of the v-belt pulleys.
3.
Remove and discard the old pulleys.
4.
Install the new pulleys using the set screws provided.
NOTE: On older lathes without the drive shaft key, the
pulley set screws must engage the 2 recesses in the
pulley shaft to properly position the pulley for correct v-
belt alignment.
5.
Align the motor pulley to the wormshaft pulley using
a straight edge.
6.
Install the new v-belt on the pulleys.
7.
Poly V-Belt Tension Adjustment:
The poly v-belt should be adjusted to deflect 3/32”
with a 5 pound push on the belt. The ideal tension is
the lowest tension at which the belt will not slip
under the highest load.
Check and adjust as required.
8.
Apply the decal provided to the top outside surface of
the belt cover.
940168 10/96
© COPYRIGHT 1996 HENNESSY INDUSTRIES AND AMMCO TOOLS ALL RIGHTS RESERVED PRINTED IN U.S.A.
CAUTION
Pulley
Pin
Rubber Tube
Installation Instructions – 4000 Lathe
To avoid damaging the lathe,
install the pin in the small hole
of the pulley before installing
the pulley on the lathe.
1.
Place the larger (worm) pulley on a bench with the
small diameter facing up.
2.
Drive the pin into the small hole of the pulley until the
pin protrudes 3/4” from the face of the pulley.
3.
Slip the rubber tube over the pin.
4.
Remove the v-belt from the lathe and discard.
5.
Back the set screws fully out of the v-belt pulleys.
6.
Remove and discard the old pulleys.
7.
Install the new pulleys using the set screws provided.
NOTE: On older lathes without the drive shaft key, the
pulley set screws must engage the 2 recesses in the
pulley shaft to properly position the pulley for correct v-
belt alignment.
8.
Align the motor pulley to the wormshaft pulley using
a straight edge.
9.
Install the new v-belt on the pulleys.
10. Poly V-Belt Tension Adjustment:
The poly v-belt should be adjusted to deflect 3/32”
with a 5 pound push on the belt. The ideal tension is
the lowest tension at which the belt will not slip
under the highest load.
Check and adjust as required.
11. Apply the decal provided to the top outside surface of
the belt cover.
CAUTION