Anchor ORIGINAL PARTY TENT LINER - Manual

PTL-1102
SLIP CABLE LOOP
OVER POLE SPIKE
PULL ROPE
HOISTING
ROPE TO
BALE RING
VELCRO JOINS (2) HALVES
OF LINER. FIRST, SECURE
WITH FASTEX BUCKLES AT
TOP & BOTTOM
PULL ROPE (PASSES
THROUGH BALE RING)
PARTY TENT
POLE
2-PC BALE RING
FLATTENED
BALE RING
FITTINGS
BALE RING
LANYARD
W/ EYELETS
BALE RING
BOLTS
PULL
ROPE
WALL ROPE HOOKS AT
PERIMETER EDGE (EAVE)
LOWER
PULLEY
T
O
UPPER PULLEY
UPPER
PULLEY
VELCRO
1. During tent installation, before standing the center pole, pass the cable
loop of the top pulley over the spike at the top of the center pole.
2. Lower the bottom pulley (w/ lanyard) to a convenient working height.
3. Pass each half of the bale ring through the loops at the peak circles of
each half of the liner.
4. Bolt the two halves of the bale ring together, capturing the eyelets of the
bale ring lanyard with the same bolt. Be sure the pull rope passes through
the bale ring.
5. Join the two halves of the liner by connecting the FASTEX buckles at the
top and bottoms of the velcroed edges.
6. Seal the velcro strips to join the two halves of the liner continuously.
7. Using the pull rope, raise the liner approximately 2/3 of the way to the
peak.
8. Attach the perimeter hooks to the wall rope at the eave line of the tent.
9. Hoist the Liner to within approximately 1 to 1-1/2 feet of the peak.
INSTALLATION SEQUENCE:
PARTY TENT LINER
INSTALLATION INSTRUCTIONS
11-23-02
VELCRO
VELCRO
VELCRO
LOWER PULLEY