Anchor ANCHORSPAN LINER - Manual

ANCHOR SPAN LINER
GABLE END OF
LINER - ATTACHED
TO FIRST MID.
STEP 1
BE CERTAIN GABLE END VELCRO IS OPEN BEFORE BEGINNING INSTALLATION. CONNECT PULL ROPES TO D-
RINGS AT LOWER ENDS OF LINER MID.
STARTING AT CHANNEL OPENINGS IN BEAMS, SLIDE KEDAR INTO INSIDE CHANNELS OF BEAMS. START BOTH
SIDES OF MID AT THE SAME TIME.
MIDS WILL BE PULLED IN WITH PULL ROPES. PULLEY MAY BE ATTACHED AT TOP ARCH OF FRAME FOR THIS PUR-
POSE, OR PUSH POLES CAN BE USED.
KEDARS
GABLE END VELCRO
MUST BE OPEN
BEFORE PULLING
LINER IN CHANNEL.
FIRST MID WITH GABLE
END ATTACHED.
FIRST MID WITH GABLE
END ATTACHED.
MID
CROSS SECTION LOOKING
AT SIDE OF ANCHORSPAN
GABLE END
ATTACH GABLE END TO
FRAME AT EAVE BAR.
ANCHORSPAN
BEAM (TYP.)
SLIDE KEDAR INTO
BOTH CHANNELS
SIMULTANEOUSLY.