Anchor NAVI-TRAC 40 WIDE HIP-END - Manual (Page 17)

UNITS WITH (2) OR MORE MID BAYS
ADDITIONAL GUIDE
BARS CAN BE
PURCHASED
1
2
3
MIDDLE BEAMS THAT ARE NOT A PART
OF AN END MODULE USE THE HINGED
BASEPLATE (FOR PIVOTING TO VERTICAL).
FIXED PLATES ARE STAMPED “END” AND SHOULD BE
USED ONLY ON END MODULES.
IN UNITS WITH MULTIPLE MIDDLE BAYS, THE SECOND
HIP END MODULE CAN BE ASSEMBLED AT THE SAME
TIME AS THE FIRST OR LATER AFTER THE MIDDLE
BEAMS HAVE BEEN INSTALLED.
FOR MOST EASE, MAKE CONNECTIONS IN
THE ORDER SHOWN IN EACH BAY.
WHEN FRAME IS COMPLETE, MID
PANELS ARE INSTALLED THE SAME AS
PREVIOUSLY SHOWN IN THE SINGLE MID
BAY CONFIGURATION.
4
5
17
DIAGRAM SHOWING UNDER
SIDE OF FABRIC AT EAVE.
FOLD CURTAIN AND CATENARY BACK
ON TOP OF MID SO THAT THEY ARE
OUT OF THE WAY.
SNAP OF PULL ROPE MUST BE
FASTENED TO PULL WEB ON
UNDER SIDE OF FABRIC PIECES.
SNAP MUST FACE AWAY FROM
KEDAR.
KEDAR
FLAP - ONLY ONE
SIDE OF MID OR
END WILL HAVE
THE FLAP.
SAFE ATTACHMENT OF PULL
ROPES TO FABRIC