Anchor NAVI-TRAC 50 WIDE HIP-END - Manual (Page 19)

Wall Installation
Step 1
Determine which side of wall
is inside and out. Ground bar
pockets are on outside, Lace flap
is on inside. Start by feeding top
of kedar edge into channel open-
ing until top of wall is as far as it
will go. (Figure A)
Insert the bottom edge of kedar
into channel opening and feed
down until wall is smoothly in-
stalled into upright.
Step 2
Starting with wall tab nearest the
lace, insert into slotted opening
in bottom channel of eave bar.
Feed rest of wall tabs into chan-
nel.
Step 3
Repeat with the matching half of
the wall.
Step 4
Lace wall starting at top of wall
bringing top loop thru the top
grommet of matching half of wall
to inside of wall. Continue with
this process looping next loop
thru grommet and then the up-
per loop until all loops are laced.
(See Figure B) Tie off bottom
loop to keep lace together.
Step 5
Slide ground bar (Figure C) thru
pocket on outside of wall. Fas-
ten to frame using the ground bar
keeper as noted on next page.
Outside View
Channel
opening Channel
opening
Inside View
Eave Bar
Lace Flap
Eave Bar
Velcro for lace
fl ap
Lace loops thru
grommets
Wall tabs
Ground bar
pocket
Ground bar
Figure A
Figure B
Figure C
19