Anchor CENTURY 50 WIDE - Manual (Page 9)

TIE DOWN AFTER
LACING
After lacing and snapping sections, attach
guys and insert loosely into tension
winches.
Insert guy web into slot in winch drum and
rotate 1 1/2 to 2 times to secure web.
RAISE SIDE POLES
Start at downwind side. Insert each side
pole pin into side pole hole and raise slightly
less than perpendicular.
Bottom of each pole should be pointed
inward toward center of tent.
Wall ropes should run outside of corner
poles and side poles.
Tie jump rope around each side pole as it is
inserted in pole hole.
Continue around tent.
5
6
SIDE POLES INSTALLED
ON DOWNWIND SIDE
WEBS
ATTACHED
LOOSELY
LACE
Web Guy
Web
Release
(Push
Downward)
Winch
Drum
SEE WEB GUY LAYOUTS FOR
STAKING CONFIGURATIONS.
7
Raise center poles nearest to wind
direction to approximate position.
One installer to guide center pole pin
through hole to prevent snagging or
tearing of fabric as pole is being raised
to position.
Keep pole at a slant until other pole
at the same lace is raised. Tie jump
ropes as each center pole is placed in
approximate position. Adjust bases of
poles to exact location and align poles
vertically.
CAUTION: At this point, it is
required to properly anchor bases of
all center poles to prevent movement.
JUMP
ROPE
JUMP ROPE
9
RAISE CENTER POLES