Anchor FUNBRELLA SHARK - Manual (Page 5)

3 ATTACH RAFTERS AND BRACES
Attach braces to clamp on each rafter with 5/16” x
7/8” carriage bolt and acorn nut.
Attach rafter to top casting and brace to lower cast-
ing with 5/16” x 1 1/2” cap screws and lock nuts.
Place top plug onto end of pole.
CAUTION
Position eye ends of braces between ears of rafter
clamps (see detail) and be aware of rafter ends
when working under the frame to avoid physical
injury.
Over tightening of nuts can result in frame damage.
When attaching rafters and braces, tighten to where
one and a half threads are exposed. This allows
free movement of parts.
4 PLACE TOP ON FRAME
Using handle, crank winch clockwise to open frame
partially. Place top with leather patch covering top
plug and drape over frame.
For Sunbrella Tops, pull hooks to ends of rafters
and through cap. Snap boot. Crank winch to open
fully and insert safety pin.
For UV Shadecloth Tops, pull hook to end of one
rafter and through cap. Proceed next to the rafter
directly opposite the first rafter. Using short bursts,
pull the fabric down until fabric is loosened enough
to reach the end of the rafter. Proceed around the
frame using the short-burst method as required.
Fasten Velcro ties around rafters. Crank winch to
open fully and insert safety pin.
WARNING:
When operating winch, handle must be on winch nut
and under control of operator to prevent rapid clo-
sure of FUNBRELLA.
IMPORTANT
Proper installation suitable to site conditions is the
responsibility of the installer.
For removal of pole, reverse steps 1 through 3 to
prevent frame damage.
CAUTION
When high wind conditions are expected, or
when lowering the Funbrella overnight, close the
FUNBRELLA and tie the bows together to
minimize movement that can cause accelerated
wear. (See warning on page 7)
TOP CASTING
RAFTER
BRACE
LOWER
CASTING
TOP
WINCH
HANDLE
RAFTER
SNAP
RAFTER
BOOT
RUBBER
CAP
RAFTER
CASTING
POLE
SAFETY
PIN
CABLE
5
HOOK