Anchor CLASSIC SOLID SAFETY POOL COVER GROUND TUBES AND STAKES - Manual

GTP 1013
INSTALLATION INSTRUCTIONS FOR
EC4734
GROUND TUBES
Water in pool
Pool Cover
Ground tube
Water in pool
Do not angle pool cover ties or springs down to
soil level. Spring or Tie may fl y off. Soil must
be built-up to deck of pool level.
Always place stake or ground tube as close to
pool deck as possible.
Pool Deck
Pavers Setting
Bed
Pool Deck
Earth
Pavers. Drill 1” diameter hole thru paver for
ground tube. Top of ground tube must be fl ush
w/top of paver. IMPORTANT: Do not install
Ground tube in fi rst row of pavers adjacent to
pool.
Figure 1
Figure 2
Figure 3
Top of ground tube must be flush
with top of ground.
Spring or tie
Ground tube
Earth
Spring or tie
Important: Consult paver
manufacturer for drilling
recommendations.
Pool Deck
Inspect Site!
Caution:
1. Consult your local utility locator service or the
National Utility Locating Contractors Association
(NULCA) prior to installation.
2. Consult design information on pool for plumb-
ing/electrical line placement.
1. For each installation the installer is solely
responsible for evaluating the site and determin-
ing the proper method and equipment to secure
the cover. Some soils require different staking or
securing than that provided with the pool cover.
Due to this variety of soil conditions, the installer
must insure proper anchoring at each anchor
point.
2. This instruction sheet must be used along
with the pool cover installation instruction manual
included with your pool cover.
3. The soil at the installation site of each ground
tube must be capable of allowing the cover to
support the minimum loads of ASTM F-1346 after
installation.
4. Testing of soil conditions and responsibility for
load verifi cation is solely the responsibility of the
installer.
One ground tube per tie or spring.
GROUND TUBE IN SOIL
GROUND TUBE THRU PAVERS
1’-3”
9”
Pool Cover