Aquascape Downspout Filter (30166) - Manual (Page 2)

Drill Here
a q u a s c a p e r a i n x c h a n g e ™
2
c a p t u r e > f i lt e r > r e u s e
3
Downspout Filter
1) Mark the Location
Mark the location that you will be
excavating for the Downspout Filter. Make
sure that the back edge of the unit is behind
your downspout outlet. Downspout filter may
be located away from foundation if desired
by extending the downspout.
2) Excavate the Hole
Excavate the hole 18” deep. You may need to elevate the
Downspout Filter in order for the water to properly travel
to the modular storage basin using gravity.
3) Add Gravel and Level
Place a 4” layer of gravel underneath the Down-
spout Filter and level side-to-side and front to
back. The gravel will allow the small quantity of
water remaining in the filter to percolate into the
surrounding soil.
*Please note that the Downspout Filter unit
does not come with percolation holes. If
desired, drill two 1/8” holes in the bottom of
the unit to allow any water remaining in the
Downspout Filter after a rainfall to slowly
percolate through the filter, preventing
stagnant water from residing in the filter.
4) Backfill on All Sides
Backfill on all sides of the filter. Be sure to leave the
outlet open so that you can connect the drainage pipe.
5) Dig the Trench
When the unit is securely installed, dig a trench from
the Downspout Filter to the Modular Storage Basin. Keep
the trench depth at the same level as the Downspout
Filter hole and line with gravel. This will help the per-
colated water from the bottom of the filter travel away
from the foundation. (In order for water to flow correctly
from the Downspout Filter into the Modular Storage
Basin, a minimum 1” downward elevation change is
recommended for every 10’ run of drainage tile.)
6) Install the Drainage Tile
Install 3” or 4” non-perforated drainage tile securely
to the barbed outlet on the Downspout Filter and finish
backfilling around the unit.
7) Run Drainage Tile to Basin
Place drainage tile over the exposed liner
and geotextile material. Hide the drainage
tile by using rocks and/or boulders.
8) Install the Filter Net into the Unit
Installation Instructions &
Maintainence Owners Manual
Bottom View