ArcOne Python - Manual (Page 4)

Care and Maintenance
Your new filter requires virtually no maintenance other than periodic cleaning when lens becomes dirty or
clouded from smoke. ArcOne ® Auto-Darkening Filters are water-resistant and may be cleaned by using a
soft cloth with soapy water solution, or standard window cleaner. Welding helmet may be cleaned with soft
cloth and soapy water. By changing cover plates frequently you will extend the life of your filter and guar-
antee the best operation possible. Additional front and rear cover plates are available from your ArcOne ®
distributor. Do not submerge filter or welding helmet in water or solution. Store in original or similar pack-
aging and store in a safe dry place away from direct heat between 14 - 100°F (-10 - 38°C).
iDF81: battery, located in the external control center will last 3-6 months depending on usage.
Replace with AAA battery of same voltage (1.5 V).
WARNING! Using the wrong cover plates may damage your product, compromise UV/IR protection,
and VOID WARRANTY. Use genuine ArcOne ® replacement parts to ensure quality and fit.
Make sure there is no damage to the helmet shell including, but not limited to cracks, holes, and melt-
ing. Ensure that the springs holding the filter are not broken or corroded. Do not use the helmet if any
of these conditions exist and contact your distributor for replacement parts. Use only replacement
components as specified for each welding helmet in accordance with this user manual.
SPATTER DAMAGE IS NOT COVERED BY WARRANTY
Please use only ArcOne ® 0.040” cover plates in these products.
NOTE: Change your cover plate when it loses its flexibility and/or becomes bowed or distorted. Clean
any build-up from the area where the cover plate is retained.
LIMITED WARRANTY
ArcOne ® warrants all auto-darkening filters listed in this manual against all manufacturing defects result-
ing from materials or workmanship for a period of 2 years from the date of purchase. Proof of purchase
establishing the date of sale and filter serial number must be provided, should a warranty claim be sub-
mitted. The purchaser’s only remedy under this limited warranty shall be limited to ArcOne ® sole opera-
tion to repair, replace or refund (not to exceed the purchase price). This limited warranty is not
transferable from the original purchaser to a secondary owner. ArcOne ® shall in no event be liable or re-
sponsible for any injury, damage or loss resulting either directly or indirectly from the use or misuse of
this product. This limited warranty is exclusive and is in lieu of any other warranty implied either oral or
written. Please read the instruction manual carefully to avoid certain situations which may void this lim-
ited warranty.
In the unlikely event that the auto-darkening filter malfunctions, the following procedures are to be
used to receive efficient service and repair: Determine if the product is damaged from abuse or mis-
use. Any pitted marks on the filter possibly from spatter, chips, dents, or cracks, etc., are some indica-
tions of operator abuse. In the case of operator abuse the warranty is void.
If you need to return your filter, follow the Return procedure below.
RETURN PROCEDURE
Please do not contact the distributor or retailer from whom you purchased the filter
1. Remove the Auto-Darkening filter from the helmet. Record the model number and serial
number which are located on the filter edge or back. Also record the date of purchase from
your sales receipt.
2. Contact ArcOne ® Customer Service (800-223-4685) for a Return Tag Number.
®
ArcOne
® is a Division of A.C.E. International Company
85 Independence Drive, Taunton, MA 02780
TEL
: (508) 884-9600 •
TOLL FREE
: (800) 223-4685 •
FAX
: (508) 884-9666
WEB
: www.arc1weldsafe.com