Artograph 1530 Spray Booth - Manual (Page 4)

OPERATION
1. Always place the item to be sprayed in the center of the fi lter.
3-D objects can be mounted on a piece of scrap cardboard
or fl at material that is slightly larger than the object.
2. Small parts may be hung with string or wire from the holes in
the top brace for more convenient spraying.
3. Avoid mounting fl at materials or objects that cover up more
than 75% of the fi lter area. Restricted airfl ow and poor fi ltering
will result.
4. After each use, leave the unit on for a few minutes, this will
continue to circulate the air in the room and remove further
airborne contaminants.
Please Note: Increased odors can be a clue to reduced fi lter
effectiveness, but not necessarily. The 1530 spray booth will
do an excellent job of reducing the over-spray from aerosols
and airbrushes, but the intensity of odors vary from product
to product. The 1530 will reduce the odors, but it will not
totally eliminate them. Exhausting the fumes outdoors is
the best remedy for eliminating odors.
ROUTINE MAINTENANCE
Filters (see illustration on next page) – Available from where you
purchased your spray booth or directly from Artograph. See enclosed
ordering blank or contact our web site at www.artograph.com
Pre-Filter Material – Replace whenever it becomes soiled or
coated. Sheets may be replaced with an economical roll. See
optional accessories (about every 90 surface-sprays).
Polyester fi lter/Poly-carb fi lter – Replace these fi lters as a unit
when the polyester fi lter becomes visibly soiled or coated. It is
recommended that they be replaced approximately every three
months.
REPLACEMENT PARTS
1. 225-346 1530 Pre-Filter (20 sheet pack)
2. 225-347 1530 Filter Pak (4 ea. mid-fi lter & poly-carb)
3. 200-765 1530 Metal Hood
4. 145-261 Power Switch
5. 145-535 Fan Motor (2) Not Shown
OPTIONAL ACCESSORIES
1. 225-348 1530 Roll Filter Tray
2. 225-349 30” x 50 yard Pre-Filter Roll
1. Pre-Filter
2. Mid-fi lter
(green side down)
2. Poly-carb
(black carbon)
3. Metal Hood
4. Power Switch