Artograph BEADGLO Light Box - Manual (Page 3)

BeadGlo TM Applications
This portable light box is an indispensable tool
for your beading and craft projects.
Place beads onto the trays and
turn the light on:
• Compare contrast, colors, quality and
fi nishes of beads and sort accordingly using
the custom design trays.
• The design trays can also be used just for
designing with their versatile compartments,
channels, and different compartment
shapes.
Design Trays
• Each BeadGlo
TM comes with two different
design trays with covers (replacements and
other tray designs sold separately). Each
tray can serve a different function or aspect
of beading, whether to sort beads, string
multi-strands or single strands, use small
crystals or larger lampwork beads, or even
when working with seed beads.
• The trays are versatile, lightweight, portable
yet durable, and should offer you a myriad
of designing possibilities.
• To put the tray in place, line up the circles
on the upper part of the tray with the knobs
on the work area and press down. This
will hold the tray fi rmly in place. To remove,
simply lift the bottom of the tray upward.
Ruler
• Peel the sticker and put it on the work area,
on a tray, or wherever you would like it. The
great feature of the ruler is how it starts
with 0 (zero) in the middle and then grows
in increments on either side. This way you
can put your focal piece in the middle of the
design channel and work outwards.
Design Ideas
Go to www.artograph.com for design ideas!
Maintenance
Cleaning
Clean the plastic surface and the design trays
with a soft cloth and non-abrasive cleaner. Do
not apply cleaner directly onto light box as it
may seep inside the unit.
Lamp Replacement (See Figure 3)
Caution: Be certain that the BeadGlo TM
is unplugged and the power is off before
replacing the lamp.
To remove lamp
1. Pry open the side edge of the plastic
tracing surface and remove with a
screwdriver, as indicated in the diagram.
2. Grasp lamp with both hands and turn it
approximately a ¼ turn towards you until
the tension releases. Lift and remove the
used lamp.
To Install Lamp
(See Figure 4)
1. Insert both ends of the lamp with the
prongs vertical into the lamp socket.
2. Turn the lamp approximately ¼ turn until
you feel it lock into place.
3. Snap plastic work surface back into place
using slight pressure on all four sides.
3
Figure 3
•
Figure 4 •