Atop Technology SE5404D Quick Start - Manual

SE5404D Series
4-Port Serial Device Server
Quick Start Guide
Version 1.4 March 2013
This document is intended to provide customers with
brief descriptions about the product and assist customers
to get started. For detailed information and operation of
the product, please
refer to the product user’s manual in
the product CD or Atop website.
PN: 89900377G
1. P ACKAGING
Check whether your package contains following items:
◎ SE5404D/ SE5404D-TB / SE5404D-Sis
◎ Quick Start Guide with Warranty Card
◎ Product CD
◎ 7-pin Terminal Block ( 2ESDVM-07P) x1
◎ Four 5-pin Terminal Block for COMs
(SE5404D-S5 / SE5404D-Sis only)
Optional Accessories：
◎ US Power Adapter 50500151120009G
◎ EU Power Adapter 50500151120019G
◎ Wall Mount Kit 202EH731000003G
◎ Grounding Cable 59906861G
◎ Conductive DIN-Rail Kit 201EH731000005G
◎ Console Cable 50891971G
◎ DB9 to TB5 Converter 59906231G
2. H ARDWARE D ESCRIPTION
NOTE:
1. SE5404D (RS-232/422/485 DB9 without isolation ),
2. SE5404-TB (RS-232/422/485 TB5 without isolation)
3. SE5404D-Sis (RS-422/485 TB5 with isolation)
4. Press the Default button of SE5404D to reset to the
default value
Figure 2.1. SE5404D Series interfaces
LED Indicators:
Name Color Status Description
Power Green
Off Power is not connected
On Power is connected
LAN
Green
Off Ethernet Disconnected
Blinking
Data is transmitting on
Ethernet for 100Mbps
Orange Blinking
Data is transmitting on
Ethernet for 10Mbps
COM Green
Off
No data is transmitting on
COM port
Blinking
Data is transmitting on
COM port
RUN Green
Off
System is not ready or
halt
Blinking
AP firmware is running
normally
Installation Procedures:
Step 1: Connect SE5404D to power source
Step 2: Connect SE5404D to the Ethernet network. Use a
standard straight-through or cross-over Ethernet
cable Always make sure the PC is on the same
network subnet as SE5404D.
Step 3: Connect SE5404D ’s serial port to a serial device.
Step 4: Mount SE5404D to a Din Rail.
3 S OFTWARE S ETUP
Default Settings
User Name: admin Password: null (blank)
LAN1 LAN2
IP: 10.0.50.100 IP： 192.168.1.1
Mask: 255.255.0.0 Mask: 255.255.255.0
Gateway: 10.0.0.254 Gateway: 192.168.1.254
To Access and Configure SE5404D:
There are three ways to access SE5404D.
1.
SerialManager Utility (included in the CD)
2. Web Browser
3. Telnet
Note that the PC and SE5404D should be in the same
subnet. If not, please your PC’s network settings or use
SerialManager to change the network settings of
SE5404D.