Auto Meter 1284 - Manual

12V BATTeRY
INSTALLATION INSTRUCTIONS
ANALOg Led LIT CLOCk
2650-1480-00
Setting the Time
Use the two buttons on the face of the gauge to set the time.
The left button moves the hands counter clockwise. The right
button moves the hands clockwise.
A momentary press on either button moves the hands one
minute. After pressing and holding either button for a couple
seconds, the hands will begin moving at a much faster speed,
moving the minute hand one hour in three seconds.
CAUTION!
As a safety precaution, the +12V terminal
of this product should be fused before
connecting to 12V. We recommend using a 1
Amp, 3AG fast-acting type cartridge fuse
(Littlefuse® # 312 001 or an equivalent).
Installation
1. Check that you have all parts required for installation.
2. Disconnect the negative (-) battery cable.
3. Gauge mounts in a 2 1 ⁄
16
” hole. Use supplied
brackets and nuts to secure to dash.
4. Attach black wire from harness to good engine ground.
5. Attach red wire from harness to a constant +12V terminal on
ignition switch or other +12V constant power source. Use an
un-switched power source.
6. Attach white wire to dash lighting or switchable
+12V light source.
7. Reconnect negative (-) battery cable.
12 MONTH LIMITed WARRANTY
Auto Meter Products, Inc. warrants to the consumer that all Auto Meter High Performance products will be free from defects in material and workmanship for a period of twelve (12) months from date of the
original purchase. Products that fail within this 12 month warranty period will be repaired or replaced at Auto Meter’s option to the consumer, when it is determined by Auto Meter Products, Inc. that the product
failed due to defects in material or workmanship. This warranty is limited to the repair or replacement of parts in the Auto Meter instruments. In no event shall this warranty exceed the original purchase price of
the Auto Meter instruments nor shall Auto Meter Products, Inc. be responsible for special, incidental or consequential damages or costs incurred due to the failure of this product. Warranty claims to Auto Meter
must be transportation prepaid and accompanied with dated proof of purchase. This warranty applies only to the original purchaser of product and is non-transferable. All implied warranties shall be limited in
duration to the said 12 month warranty period. Breaking the instrument seal, improper use or installation, accident, water damage, abuse, unauthorized repairs or alterations voids this warranty. Auto Meter
Products, Inc. disclaims any liability for consequential damages due to breach of any written or implied warranty on all products manufactured by Auto Meter.
SeRVICe
For service send your product to Auto Meter in a well packed shipping carton. Please include a note explaining what the problem is along with your phone number. If you are sending product
back for Warranty adjustment, you must include a copy (or original) of your sales receipt from the place of purchase.
FOR SERVICE SEND TO: AUTO MeTeR PROdUCTS, INC. 413 W. Elm St., Sycamore, IL 60178 USA (866) 248-6357
Email us at [email protected]
http://www.autometer.com
2650-1480-00 11/17/09 © 2009 Auto Meter Products, Inc
The Super Bezel is a registered trademark of Auto Meter Products, Inc.
GOOD
ENGINE
GROUND
UN-SWITCHED
+ 12V CONNECTION
RED
BLACK
FUSE
(SEE CAUTION)
+12v DASH
dO NOT HOOk TO ALTeRNATOR
WHITE
Right Button Left Button