Auto Meter 4387 - Manual

INSTALLATION INSTRUCTIONS
Digital Pro-Shift System
Level 1 Gauges and Tubes
2650-1123A
QUESTIONS:
If after completely reading these instructions you have questions regarding the operation or installation of your instrument(s),
please contact Auto Meter Technical Service at 815-899-0801.
You may also email us at [email protected].
Additional information can also be found at h ttp://www.autometer.com/tech_faq.aspx
INTRODUCTION
Thank you for your purchase of the Digital Pro Shift System (DPSS) from Auto Meter Products, Inc. The new technology in this product makes it possible to do
away with traditional plug-in chips while providing a combination of features only previously available on our larger Shift-Lite and Playback tachometers.
The following basic features are included on this product:
• Single precise user-programmable set point • Digital RPM display • RPM display blanking in preset/record modes
• Quick-reacting, intensely-bright LED shift light • User selectable dimming function
Please read and follow the instructions below regarding the installation and operation of your DPSS to receive maximum benefit and accuracy from this product.
Failure to follow the information below will void the product warranty and may result in damage to your vehicle, this product, and/or personal injury.
NOTE: This product features InTEnSELY-BRIGHT LEDS! This feature is intended for maximum driver visibility during daytime operation and high glare
situations. Usage of this product at full brightness during nighttime or extremely dark settings may adversely affect driver’s vision. Auto Meter strongly
recommends that you familiarize yourself with the dimming function of this product and that you do not operate the product at full brightness during
dim or dark lighting conditions.
INSTALLATION
1. Disconnect the negative (-) battery cable.
2. Gauge can be mounted in a 2
1 /
16
" dia. hole wit h the bracket supplied. Gauge can also be mounted in an Auto Meter Mounting Cup, Panel,
or Auto Meter Gauge Works Pod.
3. Wire gauge as indicated. See schematic on following page for more info:
Red Wire: Connect to a fused and switched 12V positive source that is turned on and off with the ignition switch.
Black Wire: Connect to a good engine, chassis, or battery ground.
Green Wire: Connect to the negative terminal of a standard ignition coil, or to the “Tach Output” terminal on the Electronic Ignition Module. (See diagram)
QUICk SET OPTIONS:
Remove RPM Display – Sometimes fewer distractions are better for a driver. If you want to be able to focus on just the shift light when you’re making a
performance run and don’t want to be distracted by the digital RPM display, you can disable the display function. To turn on/off the display function, press
and hold the
ENTER (–) button for 2 seconds. The display will indicate “on” or “off” to indicate which mode you will be changing to.
NOTE: This function only takes affect in preset / record modes. RPM display is always shown during real-time or Tach mode.