Auto Meter 4776 - Manual (Page 2)

12 MONTH LIMITED WARRANTY
Auto Meter Products, Inc. warrants to the consumer that all Auto Meter High Performance products will be free from defects in material and workmanship for a period of twelve (12) months from date of the
original purchase. Products that fail within this 12 month warranty period will be repaired or replaced at Auto Meter’s option to the consumer, when it is determined by Auto Meter Products, Inc. that the product
failed due to defects in material or workmanship. This warranty is limited to the repair or replacement of parts in the Auto Meter instruments. In no event shall this warranty exceed the original purchase price of
the Auto Meter instruments nor shall Auto Meter Products, Inc. be responsible for special, incidental or consequential damages or costs incurred due to the failure of this product. Warranty claims to Auto Meter
must be transportation prepaid and accompanied with dated proof of purchase. This warranty applies only to the original purchaser of product and is non-transferable. All implied warranties shall be limited in
duration to the said 12 month warranty period. Breaking the instrument seal, improper use or installation, accident, water damage, abuse, unauthorized repairs or alterations voids this warranty. Auto Meter
Products, Inc. disclaims any liability for consequential damages due to breach of any written or implied warranty on all products manufactured by Auto Meter.
SERVICE
For service send your product to Auto Meter in a well packed shipping carton. Please include a note explaining what the problem is along with your phone number. Please specify when you
need the product back. If you need it back immediately mark the outside of the box “RUSH REPAIR,” and Auto Meter will service product within two days after receiving it. ($10.00 charge will be
added to the cost of “RUSH REPAIR.”) If you are sending product back for Warranty adjustment, you must include a copy (or original) of your sales receipt from the place of purchase.
FOR SERVICE SEND TO: AUTO METER PRODUCTS, INC. 413 W. Elm St., Sycamore, IL 60178 USA (815) 899-0801
Email us at [email protected]
2650-598A 4/16/04
Warning Indicator
To adjust the warning set point, momentarily press and release the WARN button. The warning light will begin to flash and
the pointer will move to the previous set point signifying that warning set mode has been selected. Once in set mode, press
the WARN button to move the pointer down, or press the PEAK button to move the pointer up. Warning set points can only
be set in the pressure range. Three seconds after the last button press, the warning light will stop blinking and the pointer
will return to the current pressure reading. The warning set point is retained when power is removed from the gauge.
INSTALLATION INSTRUCTIONS
ELECTRIC BOOST/VAC with Warning Light and Peak Recall
Peak Recall
Press and hold the PEAK button to recall the highest pressure reading since the memory was last cleared. To clear the
memory, press and hold the PEAK button, and while still holding the PEAK button, press the WARN button. The pointer
will move to 0 psi to indicate that the memory has been cleared. Release the PEAK and WARN buttons to resume normal
operation. The peak recall point is retained when power is removed from the gauge.
This gauge is equipped to output the sensor signal to an Auto Meter Data
Logger. This feature allows you to use the same sensor for both the gauge
and the data logger. With this gauge it is no longer necessary to install two
sensors to measure the same function.
To use this feature, you must have an Auto Meter Data Logger installed in
the vehicle and purchase a cable kit (Model #9420) to connect the gauge
to the Data Logger. Pins number 4 & 10 (see illustration to right) in the
connector on the back of the gauge are the sensor signal and ground that
must be connected to the data logger.
After connecting the gauge to the data logger, the data logger must be
calibrated to the sensor.
Instructions for wiring and calibration are included with the cable kit.
5 4 3 2 1
10 9 8 7 6
Ground Neg.(-)
Sensor Signal (+)
Data Logger Output
(Back of Gauge)
© 2004 Auto Meter Products, Inc.