Auto Meter 6606-05705 - Manual (Page 2)

Normal Operation
The shift light will function as a Pit Road Speed indicator, and as a Red Line/Over-Rev light. As shipped from the factory, the shift light will turn on steady red
when the RPM reaches 9,500. When the RPM goes above 9,700 RPM, the Shift Lite/Dial will flash
RED. These RPM levels are editable using a PIC (*See note
below) model 9119. As shipped from the factory, the shift light will also function operated as a Pit Road Speed indicator as shown in the following table:
RPM RANGE BAND SHIFT LIGHT COMMENT
500-2,900 N/A Off
2,900-3,400 LOW Yellow
3,400-3,900 GO Green The RPM captured with the bottom button will be the threshold between the G0 band and the HI band
3,900-4,400 HI Red
4,400-4,900 TOO HI Flashing Red
4,900 and up N/A Off The light will remain off until the RPM reaches the red line limit
NOTE: The following table shows values with a captured
RPM of 3,900. All bands have a width of 500 RPM.
* NOTE: PIC (Programming Interface Controller) is used to
configure band widths and set up shift-lite parameters
SERVICE
For service send your product to Auto Meter in a well packed shipping carton. Please include a note explaining what the problem is along with your phone number. Please specify
when you need the product back. If you need it back immediately mark the outside of the box “RUSH REPAIR,” and Auto Meter will service product within two days after receiving it. ($10.00
charge will be added to the cost of “RUSH REPAIR.”) If you are sending product back for warranty adjustment, you must include a copy (or original) of your sales receipt from the place of
purchase.
12 MONTH LIMITED WARRANTY
Auto Meter Products, Inc. warrants to the consumer that this product will be free from defects in material and workmanship for a period of twelve (12) months from date of the original
purchase. Products that fall within this 12 month warranty period will be repaired or replaced at Auto Meter’s option to the consumer, when it is determined by Auto Meter Products, Inc. that
the product failed due to defects in material or workmanship. This warranty is limited to the repair or replacement of parts in the Auto Meter instruments. In no event shall this warranty exceed
the original purchase price of the Auto Meter instruments nor shall Auto Meter Products, Inc. be responsible for special, incidental or consequential damages or costs incurred due to the
failure of this product. Warranty claims to Auto Meter must be transportation prepaid and accompanied with dated proof of purchase. This warranty applies only to the original purchaser of
product and is non-transferable. All implied warranties shall be limited in duration to the said 12 month warranty period. Breaking the instrument seal, improper use or installation, accident,
water damage, abuse, unauthorized repairs or alterations voids this warranty. Auto Meter Products, Inc. disclaims any liability for consequential damages due to breach of any written or
implied warranty on all products manufactured by Auto Meter.
FOR SERVICE SEND TO: AUTO METER PRODUCTS, INC. 413 W. Elm St., Sycamore, IL 60178 (866) 248-6357
Email: [email protected]
© 2009 Auto Meter Products. Inc. 2650-1417-00rB 6/3/09 The “Super Bezel” is a registered trademark of Auto Meter Products, Inc.
• A new PRS RPM can be captured in this mode by pressing and releasing the bottom push button on the face of the tach while at the new desired RPM. The
width of the RPM bands and the PRS RPM can be pre-programmed using the PIC.
• The top button is used to recall the peak RPM. To clear the peak RPM, press the bottom button while holding the top button.
Peak Recall
No Function
Capture PRS RPM & Clear Peak