Axcess Network Receiver Quick Start - Manual (Page 2)

Command Receiver code Responses
00 Command completed successfully
05 Value entered is out of bounds
06 Invalid or unknown command
A ctio n C o mmand
Set baud rate to 4800 23c
Set baud rate to 9600 24c
Set baud rate to 19200 (default) 25c
Action Command
Turn off Receiver's Wiegand output 29c
Restore Wiegand output (default) 15c
Disable TTL outputs 35c
(If your installation does not require them)
Restore TTL output operations 20c
! "
3 34 70 103 13 44
72 105 14 47 75 106
21 52 80 113 22 55
83 114 24 57 93 124
27 58 94 127 33 69
100
# ! " $
Action Command
Delete unwanted ID(s) from Receiver's list <number>-
Remove all accepted Activator IDs 37c
(Receiver will still pass default ID 127)
Add an Activator ID
<number>+
Reset the list to the valid Activator ID numbers 34c
Code Reason
04 Trying to delete an ID that has not been programmed
03 Trying to delete all IDs. There must be at least one
02 Trying to enter more than 34 IDs - the maximum
TTL Output 1 TTL Output 2 Action
<number>D <number>E Set length of action signal
in seconds. Valid numbers are
000 - 255. Default: 005 seconds
10c 11c Set output to go from Low to
High
16c 17c Do not activate TTL output for
a valid Tag read. Default.
30c 31c Activate TTL output for a valid
Tag read.
13c 14c Do not activate TTL output
when alarm code received from
a Panic or Tamper Tag. Default.
27c 28c Activate TTL output when alarm
code received from Panic or
Tamper Tag.