Axcess Network Receiver Wiegand Quick Start - Manual (Page 2)

! "
A ctio n C o mmand
Change Activator ID <new number>W
Enable response to multiple Activator IDs 33c
Return to single Activator ID 19c
!
Action Command
Enable alarm data output 26c
Disable alarm data output 12c
Command Receiver code Responses
00 Command completed successfully
05 Value entered is not allowed
06 Invalid or unknown command
TTL Output 1 TTL Output 2 Action
<number>D <number>E Set length of action signal
in seconds. Valid numbers are
000 - 255. Default: 005 seconds
10c 11c Set output to go from Low to
High; i.e. trigger a signal
16c 17c Do not activate TTL output for
a valid Tag read. Default.
30c 31c Activate TTL output for any
valid Tag read.
13c 14c Do not activate TTL output
when alarm code received from
a Panic or Tamper Tag. Default.
27c 28c Activate TTL output when alarm
code received from Panic or
Tamper Tag.