Bakers Pride P-48S Manual - Manual (Page 2)

INSTALLATION INSTRUCTIONS
SECTION ITEM PAGE
1 Location 2
2 Electrical Connections 2
3 Requirements for Installation 3
4 Initial Start Up 3
OPERATING INSTRUCTIONS
SECTION ITEM PAGE
1 General Baking 3
2 General Baking Tips 4
3 Special Features 4
4 Cleaning 5
5 Service and Trouble Shooting 5
6 Installation of Decks 6
WIRING DIAGRAMS & SCHEMATICS
ITEM PAGE
P Series - 2 Chamber - 1 Ph, 2 W or 3 Ph, 3 W
(Wiring Diagram)
7
P Series - 2 Chamber - 3 Ph, 4 W - Star (Wiring Diagram) 8
P Series - 1 Chamber - 3 Ph, 4 W - Star (Wiring Diagram) 9
P Series - 1 Chamber - 1 Ph, 2 W or 3 Ph, 3 W
(Wiring Diagram)
10
P Series Counter Top Ovens - 2 Chamber (Schematic) 11
P Series Counter Top Ovens - 1 Chamber
(Schematic)
11
PX-14 & PX-16 (Wiring Diagram & Tables) 12
PARTS LISTS & WARRANTY
PX -14, PX-16 (New Style) 13
PX -14, PX-16 (Old Style) 14
P18-S & BK18 15-16
P-22BL, P-22S & P-24S 17-18
P-44S, P-44BL & P-48S 19-20
DP-2 21-22
Warranty 23
ITEM PAGE
2
IMPORTANT FOR FUTURE REFERENCE
Please complete this information and retain this manual for the life of the equipment. For
Warranty Service and/or Parts, this information is required.
Model Number Serial Number Date Purchased
CONTENTS
INSTALLATION INSTRUCTIONS
Minimum Clearance for Installation
From combustible or non-combustible construction:
Right side, Left side and Back: 3” (76mm)
1. LOCATION
Due to the heat a counter-top oven may produce, it must be placed on a non-combustible surface.
Do not store combustible materials on top of any oven.
2. ELECTRICAL CONNECTIONS
Suitable means, which will disconnect all ungrounded conductors of the circuit simultaneously,
must be provided by the installer.
Make sure electrical supply corresponds with that specified on the rating plate located in the rear of
the oven.
When installed, the unit must be connected by an earthing cable to all other units within the
complete installation and thence to an independent earth connection.
Use copper conductors only, rated at 90° C.
If a line cord is used for the installation of the unit in Europe, it should be a minimum of H07RN-F type
conforming to EN60 335-1 and/or local codes.