Bakers Pride P-48S Manual - Manual (Page 6)

6
DECK
DECK
6. INSTALLATION OF DECKS
TROUBLESHOOTING CHART
Take no action. The thermostat has
turned off the power to the heat control
switches, indicator lamps, contactors and
heating elements. When oven starts to
cool, all functions will be restored.
Turn switches to a position other than
"OFF". This will allow indicator lamps,
contactors and heating elements to
operate.
Replace fuse or reset circuit breaker.
Plug in power cord.
Replace fuse or reset circuit breaker.
Plug in power cord.
Lower the thermostat setting. Allow
ample time for heat to regulate.
Call local authorized Bakers Pride
Service Agent.
Increase setting.
Decrease setting.
Reduce Thermostat setting by 50° - 75°
below normal bake temperature. When
decks cool begin cooking and
immediately increase the thermostat
setting by 50° - 75°.
Decrease setting.
Increase setting.
Rotate pies (180°), once during each
bake or keep to the center of oven.
PROBLEM PROBABLE CAUSE SOLUTION
Indicator light is out
No power
Oven too Hot
Bottom of pies are
undercooked
Bottom of pies burn
before toppings are
cooked
Pies cook unevenly
Set temperature has been
reached.
The infinite top and bottom heat
control switches are "OFF". (DP-2
w/Infinite Switches only)
Power supply fuses or circuit
breakers are blown or have been
tripped.
Power cord is unplugged.
Power supply fuses or circuit
breakers are blown or have been
tripped.
Power cord is unplugged.
Thermostat set too high.
Thermostat may be defective.
Bottom infinite switch set too low.
(DP-2 w/Infinite Switches only)
Top Infinite switch set too high.
(DP-2 w/Infinite Switches only)
Deck temperature too hot -
especially during slow periods.
Bottom infinite switch set too high.
(DP-2 w/Infinite Switches only)
Top Infinite switch set too low.
(DP-2 w/Infinite Switches only)
Area's adjacent to oven walls are
generally hotter.