Bakers Pride CO11-G Manual - Manual (Page 8)

4. SERVICING:
NOTE: This appliance must be serviced by an authorized service agent.
a) Power supply to the unit must be disconnected before any service is performed.
b) Most of the service on the unit can be performed from the front and/or control panel side.
c) For proper servicing, access to the Control Panel side of the unit will be required.
d) It will be necessary to have access to the back of the oven for service needs related to the gas
supply , electric power supply and steam injection plumbing.
e) A system wiring diagram is provided in this manual and on the back of the service panel on the right
side of the oven.
f) All servicing must be performed by a factory authorized technician only.
g) For proper maintenance and repairs call the factory toll free (800-431-2745) for an authorized
service agency in your area.
NOTE: The Ventilation System must he inspected at least every six months and maintained clean and free
of obstructions.
8
off with a small, stiff brush. The same procedure can be followed for wire racks and rack supports. To
remove the blower wheel, loosen the set screws (2) on the hub of the blower wheel and tighten the 3/8”
wheel puller bolt (supplied) in center of hub (See Fig. 3).
Clean The Porcelain Interior:
Porcelain enamel interiors are designed to be as maintenance free as possible. However, for best results,
the oven should be cleaned regularly. Enameled interiors can be easily cleaned with oven cleaners. KEEP
CLEANING FLUIDS AWAY FROM ELECTRICAL WIRES, LIGHT SOCKETS, SWITCHES AND
CONTROL PANEL.
OVEN EXTERIOR:
Clean The Exterior Stainless Steel:
To remove normal dirt or product residue from stainless steel, use ordinary soap and water (with or without
detergent) applied with a sponge or cloth. Dry thoroughly with a clean cloth. Never use vinegar or corrosive
cleaner. Do not use chorine based cleaners.
To remove grease and food splatter or condensed vapors that have baked on the equipment, apply
cleaners to a damp cloth or sponge and rub cleanser on the metal in the direction of the polished lines on the
metal. Rubbing cleanser as gently as possible in the direction of the polished lines will not mar the finish of
the stainless steel. To remove discoloration, use a non-abrasive cleaner. NEVER use a wire brush, steel or
abrasive scouring pads, scraper, file or other steel tools. NEVER RUB WITH A CIRCULAR MOTION.
5. ILLUSTRATIONS
DRAFT DIVERTER
(VENTILATION HOOD)
STANDARD
DRAFT DIVERTER
(DIRECT VENT)
OPTIONAL
DRAFT ADAPTOR
(DIRECT VENT)
OPTIONAL
Figure 1 Figure 2