BAND-IT Ball-Lok Ties Installation - Manual

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925 Document # P29087 rev. E
© Copyright
BAND-IT-IDEX, Inc. 2010
All rights reserved
www.BAND-IT-IDEX.com
Page 1 of 1
Ball-Lok Ties
Installation
Instructions
K50289 Application Tool
K50289 Tool
Tension Settings:
All 3/16” (4.6 mm) ties: 0-4
All 5/16” (7.9 mm) ties: 0-6
Warning: Always wear safety glasses when operating hand tool.
Maximum Operating Temperature:
Epoxy coated ties = 300°F (149°C)
Uncoated ties = 572°F (300°C)
Minimum Loop Tensile Strength:
200 lbs. (890N) 3/16” (4.6mm) Epoxy coated ties
200 lbs. (890N) 3/16” (4.6mm) Uncoated ties
300 lbs. (1334N) 5/16” (7.9mm) Epoxy coated ties
300 lbs. (1334N) 5/16” (7.9mm) Uncoated ties
1. Wrap Ball-Lok Tie around Object.
2. Tighten clamp either by hand or with the K50289 Application Tool.
(K50289 tool will cut off clamp tail automatically.)
3. Cut off clamp tail when tightening clamps by hand.
(Optional)