BAND-IT C00269 JR. Hand Tool - Manual (Page 2)

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925 Document # P45087 Rev. I
© Copyright
BAND-IT-IDEX, Inc. 2012
All rights reserved
www.BAND-IT-IDEX.com
Page 2 of 3
C00269
JR. Hand Tool
NOTES:
1.
To assist in removing threaded parts, apply heat (softens locking compound).
2.
When connecting the tension screw to the slide block, or button head screws to the JR. adapter body, clean threads
(male and female) of foreign matter, then apply two drops of medium strength locking compound (Loctite 242 or equiv.)
onto male threads and connect parts together.
3.
Before using BAND-IT JR. tool check to see that the cutter blade and backing plate are fully tightened. Loose screws
can cause breakage of cutter blade or backing plate. Use hex key provided with tool to tighten screws if needed.
4.
Assemble tension handle, then attach retaining ring to tension screw in location shown. Place ring on groove, then
push ring against a hard surface such as a table until it snaps securely in place.
5.
Kit # C01899 contains one each of a C01887 band gripper, C03186 gripper spring and C01787 pin. Replace all parts
as a set to maximize tool performance. Periodic cleaning of band gripper teeth will improve tool performance.
TOOL FRAME
THRUST BEARING
SLIDE BLOCK
BAND GRIPPER
TENSION SCREW
GRIPPER SPRING
SPIN GRIP
HOOK PIVOT PIN
EXTERNAL RETAINING RING
SCREW RETAINING RING
TENSION HANDLE
CUTTER BAR HANDLE
JR. ADAPTER CAM
JR. ADAPTER BODY
JR. ADAPTER
PIVOT PIN
BUTTON
HEAD SCREW
1
Repair Parts &
Assembly