Cleaning and warranty – BAND-IT G40269 Giant II Hand Tool User Manual
Page 2
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Document # P36187 Rev. H
© Copyright
BAND-IT-IDEX, Inc. 2007
All rights reserved
www.BAND-IT-IDEX.com
Page 2 of 3
G40269 Giant II
Hand Tool
NOTE: Periodically apply food-grade white lubricant or equivalent to tension screw thread (on
page 3) to prevent excessive wear.
If tool fails to securely grip tail of clamp, follow gripper cleaning instructions above.
Refer to website for warranty information:
3. Replace pin: Align gripper hole with
slide block hole, insert pin in hole and
hammer pin in place.
2. Using a wire brush, clean all
foreign matter from teeth.
1. Remove gripper. Align gripper pin
hole with notch in tool frame. Using a
punch and hammer, punch pin out of
slide block.
Gripper Cleaning Instructions:
Cleaning and
Warranty