BAND-IT J02069 Pok-It II Tool User Manual
Operating instructions
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Document #P07087 rev. D
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved
www.BAND-IT-IDEX.com
Page 1 of 2
J02069
Pok-It II Tool
Operating
Instructions
1. Cut off adequate band from roll of
1/4” or 3/8” BAND-IT band by opening
the slot in the head of the tool with the
cut off lever at right angles to the tool.
Thread the band through the slot and
cut.
3. When sufficient tension has been applied,
release locking pawl and rotate tool over
object being clamped.
Note: For extra strength double-wrapped
band is recommended.
4. Cut off excess band by lifting cutter
lever.
5. Complete clamping operation by
tapping down ears of buckle with a
hammer or mallet.
6. Remove band wrapped around winding
mandrel by lifting up on locking pawl.
Reverse ratchet and withdraw tensioning
wrench from tool.
2. Form a clamp by threading the band
through buckle and make a fold under the
buckle. Insert tail of clamp into head of tool
and slide into slot of winding mandrel.
Depress locking pawl and tension clamp
with forward strokes of the ratchet wrench.
Jr. Preformed Clamps:
7. Insert tail of the preformed BAND-IT Jr.
clamp into the tool. Tension as shown in
steps 2 & 3. When tensioned sufficiently,
release locking pawl and rotate over object
being clamped. Cut off, leaving stub.
8. This stub should be shortened. With
cutter in the open position, Place tool
over stub, insert into slot and trim off
excess.
9. Complete clamp by tapping lip of
band over buckle and remove ratchet
wrench from tool as shown in step 6.